This printing method allows a relatively low pressure to move fast-drying liquid paint from the printing form on the printing material, in our case, rolled. Forms have a high run length, which is an advantage of this type of printing for large runs.
In that case, if the circulation is not great, then the customer will not have to pay set of forms for the next re-circulation is also not a large amount. The economic benefit is obvious.
Equipment of printed area
Printer and printing machine is one organism!
- Three 8-Colors printing machines of planetary type -W&H Soloflex 8L. The maximum possible width of the material - 850 mm with print Speed up to 200 m/min.
The presence in the machine of the hydraulic drive of the withdrawal of the plate cylinders in automatic mode allows to avoid when you stop printing, paint drying on the cylinder, and forms.
The roll shaft is in constant rotation, when you stop printing also will not dry up the ink in the cells of the shaft and not lose the ability to transfer the paint evenly on the printed form when resuming the printing process.
The presence of transverse and longitudinal register provides maximum accuracy and is not required for this stop printing.
- Two 10-Colors printing machines W&H Primaflex CM 10.
Maximum print width is 1270 mm, length – 800 mm print. Speed – up to 400 m/min.
Our machines are equipped with treatment systems "Turboclean 600", which allow a wash machine fully a little more than half an hour. Auto paint supply system also facilitates the work of printers and speeds up the printing process. Diameter-tannage control on rewinder can reach 1000 mm.
Modern service system Procontrol TS allows the printer to exercise manual control over the process and directly give commands to the equipment in manual mode when necessary.
Easy-Set automatically performs a summing up of printing units in operation.
- Automatic station for mixing of inks FÜLL Systembau GmbH, Germany. Model FS-XS K24.
With the acquisition of this station we significantly reduced the waiting time for a transition from circulation to circulation. The colorist can just specify the necessary parameters and the automation itself will tell you the procedure.
